Cleaning Guide for Small Mixers
BrontobbShucceemo > 12-20-2023, 06:59 AM
When the small mixer runs for a whole day, users need to clean the equipment thoroughly, especially the mixing host. So what should you pay attention to when cleaning the mixer?has organized the following 5 points for you, hope it can help you:
1.At the end of each day's work, always remember to clean the mixer thoroughly.
2. The mixer should be cleaned at least once during the concrete curing process to prevent the material from mixing in the drum. When performing short-term cleaning, this can be done during production pauses rather than cleaning after each shift.
3. when cleaning the mixer, in addition to cleaning it once with water, mix it with water and small stones to ensure a more thorough cleaning.
4. when performing manual cleaning, do not use a hammer to dislodge concrete blocks as this may damage the mixing arms, which is not advisable.
5. For mixer air filter maintenance, you can start with the following:
The working principle of the mixer is that the mixing shaft is equipped with mixing blades, which rotate at high speed in the mixing cylinder to be able to mix various materials quickly. This type of mixer is called the forced type and is suitable for single or double shaft mixers. The mixers can be used in a variety of concrete mixing plants and can be used in engineering or commercial applications.JDC series mixers are suitable for on-site projects, concrete laboratories and manufacturers of precast concrete components.
Manually empty the dust collector by opening the bag and removing any accumulated dust as part of your daily routine.
Unscrew the butterfly nut and gently remove the main air filter element. When cleaning the paper filter element, gently tap the end surface to make the dust fall off.
Use compressed air or an air pump to blow air from inside the stabilized soil mixing station. Be careful not to get the air nozzle too close to the filter element to prevent dust from splashing inside the element.
A light bulb can be used to dry the cartridge before cleaning it to prevent damage to the cartridge.